Place the C-6700-TEMPDrill Template on the desired mounting location.
Verify included harnesses will reach desired location without encountering interference from internal machine components.
Refer to
for further instructions.
Cci readerinstall kit
KitID
988
KitDesc
Card Only - Quantum Touch Control
(Coin Model Only)Install theC-5365Bypass Harnessby removing the coin vault switch and connecting the spade terminal connections to C-5365Bypass Harness.
Remove factory payment device bay cover or card reader mounting plate.
Place the C-6976Quantum Touch Stk Dryer Mounting Bracketinto the payment device opening and secure using the(4) C-107310-24 Hex Nut.Align theC-5414F2 Mounting Bracketwith theC-6976Quantum Touch Stk Dryer Mounting Bracketand attach using the(2) C-542010-32 x 1/4" Screws.
FasCard Mounting Guide for further instructions.
Connect Power
Cci readerinstall kit
KitID
581
KitDesc
12VDC Accessory Power
Connect the C-6204-4012VDC Power Harness to the H10 connection on the Machine Control Assembly.
Connect the green wire to a chassis ground.
The remaining end (3-pin molex) connects directly to the rear of the F2 FasCard Reader.
Connect Coin Sense Harness
Cci readerinstall kit
KitID
700
KitDesc
Coin Drop - Factory Optical
Disconnect the Coin Drop from the Machine Control Assembly.
Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.
Connect Machine Interface Harness
Cci readerinstall kit
KitID
582
KitDesc
Serial Communication / Pulse
Connect the C-5240 Machine Start Harness to the H3 connector on the Machine Control Assembly.