...
| Cci readerinstall kit |
|---|
| KitID | 841 |
|---|
| KitDesc | Coin and Card |
|---|
| Place the C-6700-TEMP Drill Template on the desired mounting location.
Verify included harnesses will reach desired location without encountering interference from internal machine components.
Refer to for further instructions.
| Cci readerinstall kit |
|---|
|
Feed the harness ends through the coin vault opening and then through the circular opening in the C-6936 Vault Mount Bracket. Spread the C-6936 Vault Mount Bracket wings outward and then insert the C-6936 Vault Mount Bracket into the coin vault. Feed the harness ends through the C-5414 F2 Mounting Bracket. Secure the C-5414 F2 Mounting Bracketto the C-6936 Vault Mount Bracket with the C-0144 Screws. Install the C-5710 Rubber Grommetinto the circular opening of the C-5414 F2 Mounting Bracket. Remove any existing coin drop. Mount the C-0905 Drop Cover using existing mounting hardware where the coin drop was previously installed.
|
Connect Power
...
...
Connect
...
240vac: Connect the brown and blue wires to connectors 3 and 5 on the terminal side closest to the circuit board.
...
Secure the green wire beneath the ground screw.
...
Connect Coin Sense Harness
| Cci readerinstall kit |
|---|
| KitID | 704 |
|---|
| KitDesc | Coin Drop: Micro Switch |
|---|
|
Disconnect the Coin Drop from the Machine Control Assembly. Connect the C-6253 Coin Sense Harness to the harness connected to the Coin Drop.
|
| Cci readerinstall kit |
|---|
| KitID | 723 |
|---|
| KitDesc | Coin Drop: Aftermarket Imonex |
|---|
|
Disconnect the Coin Drop from the Machine Control Assembly. Connect the C-6382 Coin Sense Harness to the harness connected to the Coin Drop.
|
| Cci readerinstall kit |
|---|
| KitID | 704 |
|---|
| KitDesc | Coin Drop: Factory |
|---|
|
Disconnect the Coin Drop from the Machine Control Assembly. Connect the C-6258 Coin Sense Harness to the harness connected to the Coin Drop.
|
Connect Machine Interface Harness
| Cci readerinstall kit |
|---|
| KitID | 634 |
|---|
| KitDesc | Pulse - Optical |
|---|
|
Connect the C-5254 Machine Start Harness to the P3 connector on the Machine Control Assembly.
|
| Cci readerinstall kit |
|---|
| KitID | 636 |
|---|
| KitDesc | Pulse - Micro Switch |
|---|
|
Connect the C-5256 Machine Start Harness to the harness previously connected to the coin drop micro switch.
|
Connect and Mount Reader
| Multiexcerpt include |
|---|
| SpaceWithExcerpt | CCIDOC |
|---|
| MultiExcerptName | F2 Reader |
|---|
| PageWithExcerpt | _Reader Ports |
|---|
|
...
- Feed remaining harness ends through the mounting hole as described in the F2/F3: FasCard Reader Mounting Guide.
- Connect the free end of the Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
- Connect the free end of the Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
- Connect the free end of the C-5500-115 Power Harness to port 1.
- Secure the FasCard reader to base as described in the FasCard Mounting Guide.
Machine Configuration
...