Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version 4

changes.mady.by.user Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Cci readerinstall kit
KitID841
KitDescCoin and Card

  1. Place the C-6700-TEMP Drill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to FasCard Mounting Guide for further instructions

.
Cci readerinstall kit
KitID840
KitDescCard Only
Feed the harness ends through thecoin vault opening and then through the circular opening in theC-6602Vault Mount Bracket.Spread theC-6602Vault Mount Bracketwings outward and then insert theC-6602Vault Mount Bracketinto thecoin vault.Feed the harness ends through the C-5414 F2 Mounting Bracket and C-6601 Spacer Plate

  1. .

Secure theC-5414F2 Mounting Bracketto theC-6939 Vault Mount Bracket with theC-0144Screws.Install theC-5710 Rubber Grommetinto the circular opening of the C-5414 F2 Mounting Bracket and C-6601 Spacer Plate.
  • Remove any existing coin drop.
  • Mount the C-0905 Drop Cover using existing mounting hardware where the coin drop was previously installed.

    • Connect Power

    Cci readerinstall kit
    KitID805

    1. Tap power as described in the Fascard Reader Install - Universal Concepts document by connecting the C-5211 Power Adapter Harness to the male spade connectors on the machine power panel.

      1. Connect the green wire to the ground terminal.

      2. A corner of the power panel cover may need to be bent slightly to allow the power harness egress.

    2. Connect the opposite end of the C-5211 Power Adapter Harness to the C-5602 Power Converter.

    3. Connect the C-5500-60 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

    Connect Coin Sense Harness

    Cci readerinstall kit
    KitID704
    KitDescCoin Drop: Factory

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6253 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    Cci readerinstall kit
    KitID636
    KitDescPulse

    1. Connect the C-5256 Machine Start Harness to the Coin Drop Harness previously connected to the coin drop.

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    Reader

    ...

    Machine Configuration

    ...

    Cci readerinstall footer