Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Cci readerinstall kit
KitID584
KitDescCoin and Card
  1. Place the C-6700-TEMP Drill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to FasCard Mounting Guide for further instructions.

  • Remove existing coin box.

  • Install theC-5365 Bypass Harnessby removing the coin vault switch and connecting the spade terminal connections to C-5365 Bypass Harness.
  • Bend the side tabs of the C-0940 Vault Cover outward and install into the coin vault. The tabs should snap into place securing the bracket.

  • Place the C-6700-TEMP Drill Template on the desired mounting location.
  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

  • Refer to for further instructions.
    Cci readerinstall kit
    KitID911
    KitDescCard Only - Coin Ready
    Cci readerinstall kit
    KitID906
    KitDescCard Only - Card Ready
    1. Place the C-6700-TEMP Drill Template on the desired mounting location.

    2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

    3. Refer to FasCard Mounting Guide for further instructions.

    Connect Power

    Cci readerinstall kit
    KitID595
    1. Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.

    2. Connect the C-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602 Power Converter.

    3. Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

    Connect Coin Sense Harness

    Cci readerinstall kit
    KitID700
    KitDescCoin Drop: MDC Control
    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    Cci readerinstall kit
    KitID645
    KitDescPulse
    1. Connect the C-5300-NC Machine Start Harness to the Coin 1 connector on the Machine Control Assembly.

    Cci readerinstall kit
    KitID603
    KitDescSerial
    1. Connect the C-0110-TOP Machine Start Harness to the H5 connector on the Machine Control Assembly.

    Connect and Mount Reader

    ...

    Reader

    ...

    Machine Configuration

    1. Power off the machine.

    2. Connect the C-0110-CP Jumper Plug to the H6 connection on the Machine Control Assembly.

    3. Power on the machine.

    Cci readerinstall footer