Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version 4

changes.mady.by.user Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to for further instructions.
    Cci readerinstall kit
    KitID584
    KitDescCoin and Card
    Cci readerinstall kit
    KitID851
    KitDescCard Only

    1. Remove existing coin box.

    2. Install the C-5365 Bypass Harness by removing the coin vault switch and connecting the spade terminal connections to C-5365 Bypass Harness.

    3. Bend the side tabs of the C-6936 Bracket outward and install into the coin vault. The tabs should snap into place securing the bracket.

    4. Attach the C-5414 F2 Mounting Bracket to the Coin Vault Bracket using C-0144 screws

    .

    Connect Power

    Cci readerinstall kit
    KitID663
    Tap power as described in the document using the C-5101 Spade Taps provided

    1. .

    Connect the C-5336 Power Adapter Harness to the installed spade taps.

    Connect

    ...

    Power

    ...

    Connect

    ...

    Connect Coin Sense Harness

    Disconnect the Coin Eye Harnessfrom theCoin Drop.
    Cci readerinstall kit
    KitID700
    KitDescCoin Drop: Factory

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.

    Cci readerinstall kit
    KitID883
    KitDescCoin Drop: MD2 Control

    Connect

    ...

    Machine

    ...

    Connect Machine Interface Harness

    Cci readerinstall kit
    KitID645
    KitDescPulse

    1. Connect the C-5300-NC Machine Start Harness to the Coin 1 connector on the Machine Control Assembly

    .
    Cci readerinstall kit
    KitID883
    KitDescPulse - MD2 Control
    Connect the C-6307 Machine Start Harness connector with the purple wires to the Coin Counting Board Harness where the coin drop was previously connected

    1. .

    Connect

    ...

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    Reader

    ...

    Machine Configuration

    ...

    Cci readerinstall footer