Versions Compared

Version Old Version 5 New Version 6
Changes made by

Chris Kite

Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to FasCard Mounting Guide for further instructions.
    Cci readerinstall kit
    KitID584
    KitDescCoin and Card
    Cci readerinstall kit
    KitID857
    KitDescCard Only - 10° Panel Coin Models

    1. Remove existing coin box and coin drop.

    2. Install the C-5365 Bypass Harness by removing the coin vault switch and connecting the spade terminal connections to C-5365 Bypass Harness.

    3. Attach the C-5414 F2 Mounting Bracket to the C-6765-W-R1 Metercase Bracket using (2) C-5420 10-32 x 1/4 Pan Screws.

    4. Run any card reader harnesses through the coin slot openings and the circular hole in the C-6765-W-R1Metercase Bracket.

    5. Install the C-6765-W-R1 Metercase Bracket so that the two threaded posts insert into the coin drop slots. Then secure it to the machine using the (2) C-1059 Kep Nuts and (2) C-1070-W Washers.

    Cci readerinstall kit
    KitID906
    KitDescCard Only - Card Models

    1. Place the C-6700-TEMP Drill Template on the desired mounting location.

    2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

      3. Refer to FasCard Mounting Guide for further instructions.

    Connect Power

    Cci readerinstall kit
    KitID581
    KitDescACA Controls

    1. Connect the C-6204-40 12VDC Power Harness to the H10 connection on the Machine Control Assembly.

      1. Connect the green wire to a chassis ground.

    2. The remaining end (3-pin molex) connects directly to the rear of the F2 FasCard Reader.

    Cci readerinstall kit
    KitID837
    KitDescTitanium Controls

    1. Connect the 2-pin connector from the C-6207 F2, ACA Power Harness to the 24v transformer behind the front control panel.

    2. The remaining end (3-pin molex) connects directly to the rear of the F2 FasCard Reader.

    Cci readerinstall kit
    KitID794
    KitDescACA Controls with Electronic Coin Drops
      Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.

    1. Connect the C-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to the C-5602R1 Power Converter.

    2. Connect the C-5500-84 Power Extension Harness to the appropriate connector on the C-5602R1 Power Converter. The remaining cable end connects to the FasCard reader.

    Connect Coin Sense Harness

    ...