Install Mounting Hardware
...
| KitID | 917 |
|---|
| KitDesc | Coin and Card |
|---|
...
Place the C-5700-TEMP Drill Template on the desired mounting location.
...
Verify included harnesses will reach desired location without encountering interference from internal machine components.
...
Connect Power
| Cci readerinstall kit |
|---|
| KitID | 663 |
|---|
| KitDesc | Tap Machine Power |
|---|
|
Locate the incoming power cables in the rear of the machine. This should include a white, black and green wire.
Use the C-5101 Spade Taps to tap the black (L1) and white (Neutral) wires.
Attach the spade ends of the C-5336 Power Adapter Harness to the taps. Blue to black, and Brown to White.
Attach the Green ground wire from the C-5336 Power Adapter Harness to a nearby chassis ground screw.
Connect the 3-pin connector from the C-5336 Power Adapter Harness to the 3-pin connector on the C-5602R1 Power Converter.
Connect the 4-pin connector from the C-5602R1 Power Converter to the 4-pin connector on the C-5500 Power Extension Harness.
Mount the C-5602R1Power Converter in the machine by using zip ties to secure it to the machine's wire harness.
|
Connect Coin Sense Harness
| Cci readerinstall kit |
|---|
| KitID | 693 |
|---|
| KitDesc | Factory - Optical Coin Drop |
|---|
|
Disconnect the Coin Drop from the Machine Control Assembly. Connect the C-5362 Coin Sense Harness to the harness connected to the Coin Drop.
|
Connect Machine Interface Harness
| Cci readerinstall kit |
|---|
| KitID | 590 |
|---|
| KitDesc | Pulse - AA3 / Debit Connection |
|---|
|
Connect the C-5364Machine Start Harness to the AA3 connector on the Machine Control Assembly.
|
Machine Configuration
Enter Service Mode and navigate to J option.
Set option to J.d.
Exit Service Mode.