Page Comparison

Place the C-5700-TEMP Drill Template on the desired mounting location.

Verify included harnesses will reach desired location without encountering interference from internal machine components.

Refer to FasCard Mounting Guide for further instructions.

Place the C-6700-TEMP Drill Template on the desired mounting location.

Verify included harnesses will reach desired location without encountering interference from internal machine components.

Refer to FasCard Mounting Guide for further instructions.

Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.

Connect the C-5210 Power Adapter Harness to the installed spade taps.

Connect the C-5210 Power Adapter Harness to the C-5602 Power Converter.

Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Connect the opposite end of the C-5210 Power Adapter Harness to the C-5602 Power Converter.

Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Disconnect the existing wires from the Coin Drop and connect the C-6334 Combination Coin/Start Harness to the Coin Drop.

1. Blue wires go to common (Co) and normally open (NO) on coin switch.

Disconnect the existing wires from the Coin Drop.

1. Connect the C-6334 Machine Start Harness to the Coin Drop.

2. Connect the Violet wires to Blue wires 36 & 35.

3. White wires wrapped with Violet go to Red wires 207 & 30.

4. White wires wrapped with Blue go to Brown coin blocking solenoid wires.

   1. Wrap the connectors in electrical tape to keep the bare terminals from exposing.