Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version 4

changes.mady.by.user Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Cci readerinstall kit
KitID980
KitDescSurface Mount
Optional: Remove existing payment device and cover opening usingC-0939BNA Cover Plate.Place theC-6700-TEMPDrill Template on the desired mounting location.IfC-0939 BNA Cover Plateis used, drilling mounting holes into the plate is recommended.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to

    1. Place the C-6700-TEMP Drill Template on the desired mounting location.

    2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

    3. Refer to

    for further instructions.
    Cci readerinstall kit
    KitID985
    KitDescPayment Device Bay Mounting

    1. FasCard Mounting Guide for further instructions.

    Connect Power

    Power is supplied through the same Machine Interface Harness described in step 4.

    Connect Coin Sense Harness

    Not applicable in this setup. FasCard reader does not collect payment from any other devices, and will only send funds to the machine's control.

    Connect Machine Interface Harness

    Cci readerinstall kit
    KitID839
    KitDescMDB Start Harness

    1. Connect the C-6124-MDB Machine Start Harness to the MDB connection on the Machine Control Assembly.

      1. Optional: Use the short pigtail MDB connection to reconnect any other payment devices still in use.

    Connect and Mount Reader

    1. Feed remaining harness ends through the mounting hole as described in the F2 Reader Mounting Guide.

    2. Connect the black, 10-pin connection of the C-6124-MDB Machine Start Harness to port 5 (Serial Connection Port) as shown in the image above.

    3. Connect the clear, 3-pin connection of the C-6124-MDB Power Harness to port 1.

    4. Secure the FasCard reader to base as described in the F2 Reader Mounting Guide.

    Cci readerinstall footer