Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Install Mounting Hardware

...

KitID584
KitDescCoin and Card

...

Verify included harnesses will reach desired location without encountering interference from internal machine components.

...

Connect Power

...

Power

...

Connect Coin Sense Harness

Cci readerinstall kit
KitID884
KitDescFactory - Optical Coin Drop - Coin Sense Portion of Combination Harness
  1. Disconnect the coin sensor from Terminal Board C.

  2. Connect the wires from the coin sensor to the three circuit screw down terminal with the blue, green, and red wires.

    1. Pair the harness wires to the same colored wires from the coin sensor.

  3. Disconnect the wires from the door switch and connect the white wires with female spade terminal connectors to the same locations.

Connect Machine Interface Harness

Cci readerinstall kit
KitID884
KitDescFactory - Optical Coin Drop - Start Pulse Portion of Combination Harness
  1. Connect the wires from the Terminal Board C to the three circuit screw down terminal with the blue, green, and black wires.

    1. Pair the machine wires to the the following screw down terminal wires:

      1. Blue wire to blue.

      2. Green wire to green.

      3. Red wire to black.

  2. Take the wires previously connected to the door switch and connect the white wires with male spade terminal connectors to the wires.

Connect and Mount Reader

Multiexcerpt include
SpaceWithExcerptCCIDOC
MultiExcerptNameF2 Reader
PageWithExcerpt_Reader Ports

  1. Feed remaining harness ends through the mounting hole.

  2. Connect the larger, white 6-pin connector of the C-6310 Combination Harness to port 2 (Pulse Connection Port) as shown in the image above.

  3. (Coin and Card Installation Only) Connect the smaller, white 5-pin connector of the C-6310 Combination Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.

  4. Connect the free end of the C-5500 Power Extension Harness to port 1 (Power Harness Connection Port) as shown in the image above.

Cci readerinstall footer