The following steps assume a start harness is already connected to the upper pocket control. Locate area to mount C-6410 Pulse Stack Add-On Board. Must be close enough to reader mounting location to connect the harness to. Must be on a surface that does not received direct exposure from any heating elements (If applicable.)
Clean mounting location to remove any dust and residue if needed. Remove the sticker from the back of the C-6410 Pulse Stack Add-On Board to expose the adhesive and apply to the mounting location. Attach the C-5313 Terminal Block to the Machine Control Assembly for the lower pocket. Connect the C-5356-144 Machine Start Harness to Positions 2 and 3 on the C-5313 Terminal Block. Connect the white, 6-pin connector from the C-5356-144 Machine Start Harness to the J1 connection on the C-6410 Pulse Stack Add-On Board. Insert the C-0940 Vault Cover into the coin vault for the lower pocket’s control. Apply the C-5035 Label over the coin drop opening for the lower pocket control.
|