...
Add each new piece of equipment and complete the fields below. Selecting Save will then Next will save the information and bring up the same screen with blank fields to completed fields except the **Control Field to enter the next equipment type. See the chart below of field and descriptions for reference.
| Field | Descriptions |
|---|---|
| Control | The method the card reader uses to communicate with the machine, ie: single vend or multi-vend. |
Equipment Name | Brand Name of Equipment |
| Equipment Type | 1 = Washer 2 = Dryer See last row in chart for full list of type descriptions |
| Free Dry Awards | Number of free dry awards allowed on this machine |
| Vend Price | The cost of this machine for each start |
| Bonus Allowed | When checked, Bill Bonus allowed on this machine |
| Discount Allowed | When checked, percentage discount is allowed on this machine |
| W2W Points Allowed | When checked, machine allows customer to accumulate Wash to Win points |
| Start Hours | The time the machine can be used |
| End Hours | The time the machine is no longer available to be used |
| Cycle Time | The length of each cycle on the machine |
| Pulse Length | The length of time the electrical signal is sent to the machine to represent a coindrop. |
| Door Sensor | When checked, allows compatible equipment to allow the reader to 'sense' whether the door is closed. Do not change this option once your store is set up. |
| Equipment Types | 1 = Washer 2 = Dryer 4= Vending 5= Door 6 = Door Attendant 7 = Door Employees 10 = Other 100+ = Secure Machine |
...
The readers will temporarily stop for configuration.
Select Machine Config.
To assign a reader to a machine, select the machine number in the left column. (These numbers may have been previously assigned to each machine during installation.)
Complete the fields referencing the chart below for descriptions.
| Field | Description |
|---|---|
| Card Reader Address | The assigned number given to the reader during installation |
| Line Number | The physical line connected to the control head on the X-Changer used to communicate with the reader |
| Equipment Type ID | The identifier for each equipment type established in the previous step of Machine Configuration |
| Date in Service | The installation date |
When finished, click Back and then Done. This will restart all of the card readers.
| Warning |
|---|
Entering the config module will stop all card readers from accepting cards, and preventing new equipment starts! |