Versions Compared

Old Version 20

changes.mady.by.user David Bussman

Saved on

compared with

New Version 21

changes.mady.by.user David Bussman

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Multiexcerpt
MultiExcerptNameEncore - FLW

Encore FLW Controls

  1. Press the Service Switch to enter Service Mode. The display will go blank.
  2. Press the Heavy Soil and Extra Rinse buttons simultaneously. The display will show either "0 00" if in coin mode and "1 00" if in card mode.
  3. If in coin mode, press the Start button. The display will begin flashing.
  4. Press the Cold button to change the left-most digit from "0" to "1".
  5. Press the Start button. The display will stop flashing.
  6. Press the Service Switch to exit Service Mode.

...

Multiexcerpt
MultiExcerptNameLG Giant-C (Pre 1.8/WiFi 2.0)

LG Controls

  1. Enter Programming Mode on the machine.

    Card ModelCoin ModelOPL Model
    1. Insert service card.
    2. Display will show L9C1.
    1. Dissemble upper coin box key.
    2. Take out the coin drop from the coin box.
    3. Turn on/off the toggle switch at the back of the coin box.
    4. Display will show L9C1.
    1. Push the 1st & 3rd button at the same time.
    2. Push the 2nd button 3 times.
    3. Push the START button.
    4. Display will show L9C1.
  2. Navigate to StUP>FEA1>VEnd and set to CArd.
  3. Exit Programming Mode.
Multiexcerpt
MultiExcerptNameContinental ProfitPlus

ProfitPlus Controls

  1. Connect the washer and open the door. The display will show door.
  2. Press and hold down key 1 until the Cod report appears on the display.
  3. Enter the access code into the menus by pressing the sequence of eight keys of the code without interruption. In basic configuration (when the machine is delivered) the access code to ADVANCED MODE is: 12341234.
  4. If the sequence entered is correct, the display will show Pro, corresponding to the first menu ADVANCED MODE.
  5. Keys 2 and 4 allow the selection of the precedent table menus. The menu selected is shown on the display following its keyword. To enter in it, press key 1 when displaying it.
  6. Navigate to Mod > ID and set value to '1'.
  7. Exit ADVANCE MODE.
Multiexcerpt
MultiExcerptNameMidas

Alliance Touch Controls

  1. Enter the service menu by touch and holding on the top-center of the touch screen for 3 seconds.
    1. Enter password if required.
  2. Configure the machine with the following settings:
    1. Payment Settings:
      1. Card Reader: Enabled
      2. Serial Payment System: Enabled
Multiexcerpt
MultiExcerptNameContinental HS7

HS7 Controls

  1. Swipe horizontally the upper left corner of the screen (Swipe at least 1/3 the way across the top of the screen for best results.).
  2. (If password is enabled) Enter the 4-digit numeric code (default: 1-2-3-4).
  3. Enter into the system settings menu.
  4. Select the Gear Icon, then navigate to Connectivity > Internal GirNet.
  5. Enable the Active option.