Overview

Early X-Changer systems were shipped with an ELO touch monitor (C-1057) or (C-1054).  The manufacturer has discontinued that model and is being replaced with a similar model (C-1053). 

1. This monitor (C-1053) does not have a bezel attached
2. A separate Black Front Mounting Bezel has been modified to fit both versions of the exchangers (C-1053B)                                                                                                                                                                                   
3. The galvanized bracket is different for a version 1 cabinet and a version 2 cabinet
   1. C-1053BR will fit a Version 2 cabinet
      1. Note:  If you have the smaller cabinet with ONE Lock and Core on the front door AND ONE Lock and Core on the rear door, then you have a Version 2 cabinet
      2. This bracket will be symmetrical bracket where both the right and left side indentations will be the same
   2. C-1056 will fit a Version 1 cabinet
      1. Make sure this bracket is mounted correctly, it is not symmetrical 
      2. Note:  If you have the larger cabinet with TWO Lock and Cores on the front door AND TWO Lock and Cores on the rear door, then you have a Version 1 cabinet
      3. The bracket will have two tier step on the LEFT and a single bend on the RIGHT
      4. Make sure this bracket is mounted correctly, or the front door of the exchanger will not close properly 
4. The bracket will require 8 M4 x 6mm screws
   1. ELO will provide four each in the packaging
   2. CCI will provide four each (C-1011)
5. The new model monitor may also have a separate power supply
   1. It is recommended to tie wrap this monitor power supply to the front door along the harness (Also see instructions that are included with the ELO monitor to fasten the new power adapter to your monitor)
6. The replacement system will fit BEHIND and mount from the rear of the exchangers.  Use the appropriate mounting studs on the rear of the front door

Retrofit Kits