Versions Compared

Old Version 3

changes.mady.by.user Former user

Saved on

compared with

New Version 4

changes.mady.by.user Former user

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Import Macro Repair
Div
Classtoc-header
Section
Column
width30
Panel
titleOn this Page

Table of Contents
maxLevel2
minLevel2

Column
width70
Panel
titleOverview


Multiexcerpt include
MultiExcerptNameWarning
DisableCachingtrue
PageWithExcerptCCIDOC:_General

Required Hardware

Bw part list
Partsc-0525,C-0550
SizingModeHeight
ShowDesc2false
ShowDesc3false
SingleRowtrue

Recommended Tools and Supplies (Not Included)

  • Phillips Screwdriver
  • 3/16" Hex Driver

Installation

Div
Classinstall-steps
Panel

Step 1 - Remove Control Head from X-Changer Cabinet

  1. Flip the white rocker switch on the rear of the control head to the 'Off' position.
  2. Disconnect all cables from the front and rear of the control head unit.
    1. Technical Support recommends taking a picture of the existing connections with a camera or smart phone as a reference for the re-installation process.
  3. Remove the screws securing the control head wings to the X-Changer frame.

Panel

Step 2 - Remove Control Head Wings

  1. Using the 3/16" Hex driver, remove the screws securing the wings to the control head.
    1. Set screws aside for reassembly.

Panel

Step 3 - Open Control Head

  1. Remove the screws indicated in the composite image below.
  2. Slowly lift the top panel - internal cable connections will prevent it from being removed entirely.
    1. Disconnect the USB cable.
    2. Disconnect the parallel (ribbon) cables.
  3. Top panel may now be completely removed.

Panel

Step 4 - Remove Failed Power Supply

  1. Note the location of the existing wires connected to the power supply that requires replacement.
    1. The larger power supply is the 15 volt supply and the smaller is the 12 volt supply.
    2. Technical Support recommends taking a picture of the existing wire connections with a camera or smart phone as these connections must be exactly duplicated with the replacement power supply.
  2. Remove screws securing wires to power supply.
  3. Remove screws securing power supply to control head case (located on bottom of control head).
  4. Lift the power supply free of the control head case.

Image Added

Image Added

Image Added

Panel

Step 5 - Install Replacement Power Supply and Reconnect Control Head

Bw part list
Parts1c-0550
SizingModeHeight
ShowDesc2false
ShowDesc3false
SingleRowtrue

  1. Reverse the process listed in Step 4 to install the power supply.
  2. Reverse the process listed in Step 3 to re-seal the control head.
  3. Step 5 part 1Reverse the process listed in Step 2 to reinstall the control head wings.
  4. Reverse the process listed in Step 1 to reinstall control head in the X-Changer cabinet.

Additional Information

Filter by label (Content by label)
showLabelsfalse
sorttitle
cqllabel = "controlhead" and space = "LG"