Versions Compared

Old Version 8

changes.mady.by.user Former user

Saved on

compared with

New Version 9

changes.mady.by.user Former user

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
columnpanel
Sectiondiv
Class
toc-header
borderColorcolumn
Section
#981A28Table of Contents
Column
#981A28
titleColorwidth#FFFFFF30titleBGColor
Panel
title
On this Page

Table of Contents

panelborderColor#981A28titleColor

maxLevel

2

minLevel

2

Column
#FFFFFF
widthtitleBGColor70#981A28
Panel
titleOverview
 This

This page is intended to guide the user through the process of replacing an X-Changer Card Dispenser (part no. C-1025) in a LaundryCard V2 cabinet

.

Multiexcerpt include
MultiExcerptNameWarning
DisableCachingtrue
PageWithExcerptCCIDOC:_General

Asahi Seiko Card Dispenser

The LaundryCard X-Changer cabinet utilizes an Asahi Seiko belt driven card dispenser.  This guide provides step by step instructions for replacing the card dispenser if a hardware failure should occur.

Required

...

Hardware

Bw part list
PartsC-1025

...

Recommended Tools and Supplies (Not Included)

DescriptionLink/SourceImage
No.2 Phillips Screwdriver
(Or Equivalent) 		Amazon

uidiv
Classinstall-steps
Panel
borderColorblack

Step 1 - Disconnect Card Dispenser

Replacement Guideui-step

  1. Unplug the power cable from the card dispenser (shown in red).
  2. Empty the card hopper (shown in yellow).

Image Added

Panel
borderColorblack
ui-step

Step 2 - Remove Bill Magazine from Validator

  1. Remove the bill magazine from the bill validator (located below the card dispenser).

Image Added

Panel
borderColorblack
ui-step

Step 3 - Remove Card Dispenser From Mounting Tray

  1. Locate the four (4) Phillips head screws on the bottom of the card dispenser tray, located above the bill validator.
  2. Remove all four screws and washers. These will be used to attach the new dispenser.
  3. Existing dispenser can now be removed.

Image AddedImage Added

Panel
borderColorblack
ui-step

Step 4 - Remove Card Dispenser Guide

  1. Remove the card dispenser guide (part no. C-0993) from the front of the card dispenser being replaced.
  2. Attach the card dispenser guide to the new card dispenser being installed. Do not over tighten screws- leave play for final adjustments once installed in X-Changer cabinet.

Image AddedImage Added

Panel
borderColorblack
ui-step

Step 5 - Install New Card Dispenser

  1. Install new card dispenser by performing step 3 in reverse. Do not over tighten- leave play for final adjustments.
  2. Align card dispenser such that the dispenser guide tray is flush with the door slot.
  3. Once guide tray is properly positioned, tighten screws on guide tray.
  4. Tighten dispenser tray screws.
  5. Reconnect bill validator magazine.
  6. Reconnect power cable disconnected in step 1.

Image Added

Additional Information