Page Comparison

...

1. Choose Machine Config
   
   This is the Machine Overview Page. This page sets the equipment to the correct machine number and the correct Line the machine is on.
2. Touch or click on the first Machine ID on the list.
   

3. Referencing the store layout that was provided with the system,

   enter the appropriate line number, card reader address (almost always the same as the Machine ID), and the Equipment ID (use the table below to choose the appropriate ID).
   Image Removed

   complete the fields on this page.
   Image Added
   
   

   Field	Description
   Card Reader Address	The number of the machine in the row.
   Line Number	The line number the machine is on. (Example Line 0)
   Equipment Type ID	This can be found in the list below the fields.

4. Once complete, choose the Save button, then the then Next button  to move to move the next numeric machine ID and repeat step 2

5. Once you have entered in the values for each of the machines in that numeric series, choose the Back button to return to the Machine ID listing page. 

   Note
   Typically washers start at number 1, and dryers start at 101 representing dryer number 1.

6. Using the scroll bars or scroll buttons on the screen to find the next numeric series and repeat steps 2 and 3.
7. Once complete with all machine types as identified on the store layout, choose Done. You must click Save and Next after each Equipment Type has been entered or it will not save the setup you just entered.
8. Once complete with all machine types as identified on the store layout, click Back and then Done.

Your equipment should be ready to start. At this time if the information was entered correctly the readers will start to download the appropriate firmware. This may take some time.

If the readers complete the download and the readers continue to say, “See Attendant”, there may be an error in the configuration and the equipment setup should be checked for accuracy. If the issue persists, Contact CCI technical Support.