Versions Compared

Old Version 1

changes.mady.by.user Former user

Saved on

compared with

New Version 2

changes.mady.by.user Former user

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.


Panel
borderColor#416eb6
titleColor#e6e6e6
titleBGColor#416eb6
borderStylesolid
titleOverview
This guide should be followed on a Bi-Monthly basis to ensure that your dispenser continues to perform as intended with minimal downtime.



Panel
borderColor#416eb6
titleColor#e6e6e6
titleBGColor#416eb6
titleTable of Contents
Table of Contents



Note


Card Concepts Inc takes no responsibility for data loss due to human error, hardware failure, or other such circumstances.


Bi - Monthly Maintenance

Items needed:

  1. Paper towel or Q-tips
  2. Rubber Roller Cleaning Solution


Rubber Cleaning Solution Website Purchase

Warning

DO NOT USE ANY TYPE OF ALCOHOL TO CLEAN THE ROLLERS!

Shut down


  1. Open the Add
-
  1. Value Kiosk with
a Manager Card by swiping the card on the reader.
  1. Open the card reader carriage but pulling on the latch bar and pulling up gently. Be careful to avoid snagging the wire loom above it.
    Image Removed
  2. With the carriage open, Take the keys that accompanied the system.
  3. Once open, remove the cash box from the bill acceptor.
  4. With the kiosk open, take a moment to familiarize yourself with the parts of the dispenserbill acceptor:
    Image Removed       Image RemovedImage Added
  5. Apply Rubber Roller Cleanser to paper towel or Q-tip and clean the Tension Rollers by swiping across as you roll them.
  6. Clean the Tension Bars by rubbing vigorously to remove any dirt or residue. Confirm that they are white and not yellow or dirty.
  7. Insert a test card to the first sensor just before the forward rollers and this will cause the rollers to spin.
    Image Removed
  8. While the rollers are spinning press lightly with your cleaning media for a 3 count to make sure all dirt is removed from the roller. Repeat for the remaining 3 rollers.
  9. With the Read Head exposed and with light pressure, Clean by rubbing in the direction that the cards travel through the carriage. DO NOT go side to side. 
  10. With a dry paper towel, wipe off any residual liquid from all surfaces.


Note

Repeating these steps several times may be necessary. Once finished, remove the test card from the slot and switch the power supply located behind the bill acceptor off and on again. Dispense several cards to ensure performance.