Overview
This guide should be followed on a Bi-Monthly basis to ensure that your dispenser continues to perform as intended with minimal downtime.
Table of Contents
Card Concepts Inc takes no responsibility for data loss due to human error, hardware failure, or other such circumstances.
Bi - Monthly Maintenance
Items needed:
- Paper towel or Q-tips
- Rubber Roller Cleaning Solution
Rubber Cleaning Solution Website Purchase
DO NOT USE ANY TYPE OF ALCOHOL TO CLEAN THE ROLLERS!
- Open the Add Value Kiosk with the keys that accompanied the system.
- Once open, remove the cash box from the bill acceptor.
- With the kiosk open, take a moment to familiarize yourself with the parts of the bill acceptor:
- Apply Rubber Roller Cleanser to paper towel or Q-tip and clean the Tension Rollers by swiping across as you roll them.
- Clean the Tension Bars by rubbing vigorously to remove any dirt or residue. Confirm that they are white and not yellow or dirty.
- Insert a test card to the first sensor just before the forward rollers and this will cause the rollers to spin.
- While the rollers are spinning press lightly with your cleaning media for a 3 count to make sure all dirt is removed from the roller. Repeat for the remaining 3 rollers.
- With the Read Head exposed and with light pressure, Clean by rubbing in the direction that the cards travel through the carriage. DO NOT go side to side.
- With a dry paper towel, wipe off any residual liquid from all surfaces.
Repeating these steps several times may be necessary. Once finished, remove the test card from the slot and switch the power supply located behind the bill acceptor off and on again. Dispense several cards to ensure performance.