Versions Compared

Old Version 1

changes.mady.by.user Brett Norrell (Deactivated)

Saved on

compared with

New Version Current

changes.mady.by.user Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Cci readerinstall kit
KitID727
KitDescCoin Prepped Machine

  1. Remove existing coin box.

  2. Bend the side tabs of theC-0936Bracketoutward and install into the coin vault. The tabs should snap into place securing the bracket.

  3. Attach theC-0133Standoffsto theBracket.

  4. Place the C-0906spacerbetween the reader and the machine's panel.
  5. Remove any existing coin drop.
  6. Mount the C-0963 Drop Cover using C-1062 Kep Nuts.
  7. Affix C-0031 Labelto the C-0963 Drop Cover.
Cci readerinstall kit
KitID731
KitDescEasy Card Prepped Machine
  1. Apply C-0031 Label to cover the Easy Card slot.

  2. Using the C-0970R1 Mounting Bracket, mark out cutting lines on the front panel of the machine near where a coin vault would normally be mounted. Mark the central opening, along with the two threaded holes to the sides of the central opening.

  3. Place the C-0970R1 Mounting Bracket on the inside of the panel, and C-0906 Spacer on the outside of the panel. Then secure all components and reader in place using C-5751 Screws.

Connect Machine Interface Harness

Cci readerinstall kit
KitID636
KitDescPulse - Micro Switch (Serial #: Before 515483)
  1. Connect the C-5256 Machine Start Harness to the Coin 1 terminal connections previously connected to the micro switch on the coin drop.
Cci readerinstall kit
KitID577
KitDescPulse - Optical Sensor (Serial #: After 515483)
  1. Connect the C-0127 Machine Start Harness to the P2 connector on the Machine Control Assembly.

Connect and Mount Reader

Multiexcerpt include
SpaceWithExcerptcom.atlassian.confluence.content.render.xhtml.model.resource.identifiers.SpaceResourceIdentifier@7627108f
MultiExcerptNameLC Reader
PageWithExcerpt_Reader Ports

  1. Feed remaining harness ends through mounting bracket.
  2. Connect the free end of the Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
  3. Connect the the Cat5 cables running to and from the adjacent machinesto ports labeled 3 (Line Connection Ports) as shown in the image above.
  4. Secure the LaundryCard reader to the bracket using included hardware.

Machine Configuration

TODO

Cci readerinstall footer