| Panel | ||||||||
|---|---|---|---|---|---|---|---|---|
| ||||||||
This page provides relevant information about the function and installation is intended to provide the reader with generalized details and functions of the Satellite Access Point (SAP) utilized in all FasCard & FLEX systems. |
| Bw part list | ||||
|---|---|---|---|---|
|
General information
The The Satellite Access Point Point (SAP) is acts as a bridge between the FasCard readers and the internet. The SAP has an Ethernet port that connects to the location's internet connection and a the FasCard readers, Internet, and FasCard Administration Site. To connect these components together, the SAP contains two ethernet ports intended for wired Internet communication and an internal wireless antenna that communicates with the FasCard the FasCard readers. The SAP The SAP is more than a wireless access point an average Wireless Access Point (WAP) in that it provides valuable location status information to the FasCard Administration site. Each location requires the FasCard Admin Site dynamically. Meaning, it doesn't have to be manually updated.
Each FasCard location must have a minimum of one (1) SAP to function properly. Multiple Multiple SAPs can be used to extend the wireless coverage area or provide redundancy. The wireless range of a SAP is approximately 90 feet providing coverage to 180 foot diameter surrounding the SAP. As many as a 110 card readers can be managed by a single single SAP, although there are various factors where more SAP's more SAPs may be required. The current wireless range of an individual SAP is approximately 90 feet, providing coverage in a 180-foot diameter around the SAP. While the wireless signal will operate through walls and objects, signal strength may be degraded and interference from sources generating strong electromagnetic fields is also possible likely to create issues. The SAP can be powered via a
| Tip | ||
|---|---|---|
| ||
CCI recommends installing the SAP on the ceiling or high up on a pillar, located in the middle of most (or all) readers and Kiosks to provide even coverage. |
The SAP can be powered either by a Power over Ethernet (PoE) adapter which adapter or a standard 12VDC adapter. The former eliminates the need to install a wall receptable, or other power source, at the SAPs install site. Power for the SAP the SAP is delivered through a Cat5 Ethernet cable that connects the device to the local internet connection by way of the the PoE adapter utilized during installation. SAP's can be wall or ceiling mounted with the mounting hardware provided and should be installed in a central location providing even coverage to all FasCard readers and kiosksThe 12VDC adapter is shorter in length, and will require a power source of sorts to be as close as possible to the SAPs install site.
| Note | ||
|---|---|---|
| ||
The FasCard SAP (Mikrotik 951G-2HnD) device can accept power through its power jack or through the first Ethernet port:
|
Additional
Hardware Included Withhardware included with the SAP
| Bw part list | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|