Versions Compared

Old Version 2

changes.mady.by.user Brett Norrell (Deactivated)

Saved on

compared with

New Version Current

changes.mady.by.user Chris Kite

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Required Hardware

Card Reader

...

F1 FasCard Reader

...

Cci readerinstall header

Install Mounting Hardware

Cci readerinstall kit
KitID917
KitDescCoin and Card

  1. Place the C-5700-TEMP Drill Template on the desired mounting location.

  2. Verify included harnesses will reach desired location without encountering interference from internal machine components.

  3. Refer to for further instructions.

Cci readerinstall kit
KitID817
KitDescCard Only

  1. Remove existing coin box and coin drop.

  2. Install theC-0934 Mounting Bracket over the coin vault and coin drop opening. Secure to the machine using the C-1059 kep nuts.

Connect Power

Cci readerinstall kit
KitID595
  1. Tap power as described in the document using theC-5101 Spade Taps provided.
  2. Connect theC-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to theC-5602 Power Converter.
  3. Connect theC-5500 Power Extension Harness to the appropriate connector on theC-5602 Power Converter. The remaining cable end connects to the FasCard reader.

Connect Coin Sense Harness

Cci readerinstall kit
KitID689
KitDescCoin Drop: Factory
  1. Disconnect the Coin Drop from the Machine Control Assembly.
  2. Connect the C-5357 Coin Sense Harness to the harness connected to the Coin Drop.

Connect Machine Interface Harness

Cci readerinstall kit
KitID655
KitDescPulse
  1. Connect the C-5353R1 Machine Start Harness to the Coin 1 connector on the Machine Control Assembly.
Cci readerinstall kit
KitID833
KitDescSerial
  1. Connect the C-0126-MLV Machine Start Harness to the RS-232 port on the Machine Control Assembly.
    1. If extra length is needed on the harness, attach C-0126-MLV-EXT15 Extension Harness.
  2. Connect the C-5359 Machine Start Harness to the Input port on the Machine Control Assembly.

Connect and Mount Reader

Multiexcerpt include
SpaceWithExcerptCCIDOC
MultiExcerptNameF1 Reader
PageWithExcerpt_Reader Ports

  1. Feed remaining harness ends through the mounting hole as described in theFasCard Mounting Guide.
  2. Connect the free end of theC-0126-MLVMachine Start Harnessto port 1 (Serial Connection Port) as shown in the image above.
  3. Connect the free end of theC-5359 or C-5353R1Machine Start Harnessto port 2 (Pulse Connection Port) as shown in the image above.
  4. Connect the free end of theC-5357Coin Sense Harnessto port 3 (Coin Sense Harness Connection Port) as shown in the image above.
  5. Connect the free end of theC-5500Power Extension Harness to port 4 (Power Harness Connection Port) as shown in the image above.
  6. Secure the FasCard reader to base as described in the FasCard Mounting Guide.

Machine Configuration

TODO

Cci readerinstall footer