Parts Required
title | Kit Number K-0664 |
---|
Estimated Installation Time: 30 Minutes
Multiexcerpt include SpaceWithExcerpt com.atlassian.confluence.content.render.xhtml.model.resource.identifiers.SpaceResourceIdentifier@7627108f MultiExcerptName Warning PageWithExcerpt CCIDOC:_General
Required Parts
Cci kits | ||||
---|---|---|---|---|
|
Step-by-step guide
Step 1 - Installing the lock
Disassemble
the Service Lock (098760) by removing the kep nut, kep ring, cam, and mounting nut from the lock assembly.
Push the lock core through the opening on the cover of the Printer Cabinet (C-0665) and orient it so that the inserted key is vertically parallel to the longer sides of the cabinet.
Slide the cam onto the lock shaft with the protrusions facing upward.
Slide
the kep ring and secure it with the remaining kep nut.
Step 2 - Mounting the printer cabinet
Note | ||
---|---|---|
| ||
The Receipt Printer cannot be mounted inside of an X-Changer cabinet. |
Determine a suitable mounting location
(wall or shelf) and remove the appropriate knockout.
The printer cabinet should be in between both X-Changers
or on the side of one of them for easy access.
Mark the Printer Cabinet (C-0665) cable opening on the mounting surface and drill a 1" opening
at the site of the mounting surface to allow cables to pass through.
Attach the Printer Cabinet (C-0655) to the mounting surface with appropriate hardware (not
included).
Step 3 - Installing the printer in the printer cabinet
Pass the USB
(C-1330) and Power Supply
(C-0667) cables through the
printer cabinet opening.
Connect the cables to the Receipt Printer (C-0666).
Using the slotted holes on the Receipt Printer
(C-0666), mounting the printer to the Printer Cabinet (C-0665).
Adjust the printer
so it sits toward the rear of the cabinet
.
Load paper into the printer by lifting up on the paper bar.
Lock the bar back into place and open the feeder release by pulling the blue lever.
Pull paper across the feeder and press down on the feeder
until it locks into place.
Close the
printer cabinet and turn the key to secure the lock.
Step 4 - Final connections
Connect the
USB cable (C-1330) to the X-Changer A's PC.
If the cable is unable to reach X-Changer A, then connect it to X-Changer B's PC.
Connect the Cat5
cable (C-0178) to the IOGear Print Server
(C-0618).
Connect the opposite end of the Cat5 cable (C-0178) to the network switch in
X-Changer A.
If the cable is unable to reach X-Changer A, then connect it to X-Changer B's network switch.
Connect the
Printer power supply cable (C-0667) to a power outlet.
Connect the IOGear Print Server power supply
cable (C-0618) to a power outlet.
Column | |||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| |||||||||||||||||||
|
width | 50% |
---|
Step 5 - Setting up the printer drivers
You have now successfully installed the Receipt Printer.
In order to set up the printer for the LaundryCard system, you will need to contact CCI Technical Support. You can reach them at 630-930-5115, option 2, Mon-Sat between 8 AM and 7 PM CST.
Related documents
Filter by label (Content by label) | ||
---|---|---|
|
|
|
|
|
|