Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to for further instructions.

  • Remove existing coin drop.

    • Install C-0913 Drop Cover where the coin drop was previously mounted. Secure using(4) C-10624-40 Keps Nuts.Place theC-6700-TEMPDrill Template on the desired mounting location.

  • Verify that included harnesses will reach the desired location without encountering interference from internal machine components.

  • Refer to Touchscreen Reader Mounting Guide (F2 & F3) for further instructions.

    • Optional: Use C-5710 Rubber Grommetto protect harnesses from damage during machine operation if any secondary hole is cut internally to run harnesses to the reader mounting location.
    cci-readerinstall-kit
    KitID841
    KitDescCoin and Card Install
    Cci readerinstall kit
    KitID959
    KitDescCard Only Install - Coin Model

    ...

    step
    componentMounting

    Tap power as described in the document using theC-5101 Spade Taps provided.Connect theC-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to theC-5602 Power Converter.Connect theC-5500-60 Power Extension Harness to the appropriate connector on theC-5602 Power Converter. The remaining cable end connects to the FasCard reader.
    cci-readerinstall-kitstep
    KitID802

    Connect Coin Sense Harness

    componentPower

  • Disconnect the Coin Drop from the Machine Control Assembly.
    • Connect the C-6343 Coin Sense Harness to the harness connected to the Coin Drop.
    cci-readerinstall-kit
    KitID711
    step
    componentCoin Sense

    cci-readerinstall-kit
    KitID722
    1. Disconnect the Coin Drop from the Machine Control Assembly.
    2. Connect the C-6368 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    Connect the C-5344 Machine Start Harness to the coin 1 connector on the Machine Control Assembly.
    Cci readerinstall kit
    KitID652
    step
    componentStart

    cci-readerinstall-kit
    KitID653
    1. Connect the C-5345 Machine Start Harness to the coin 1 connector on the Machine Control Assembly.

    Connect and Mount Reader

    ...

    step
    componentReader

    Machine Configuration

    None required.

    ...