Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to for further instructions.
    cci-readerinstall-kitstep
    KitID841
    KitDescCoin and Card
    componentMounting

    Feed the harness ends through thecoin vault opening and then through the circular opening in theC-6602Vault Mount Bracket.Spread theC-6602Vault Mount Bracketwings outward and then insert theC-6602Vault Mount Bracketinto thecoin vault.
  • Feed the harness ends through the C-5414 F2 Mounting Bracket and C-6601 Spacer Plate.
    • Secure theC-5414F2 Mounting Bracketto theC-6939 Vault Mount Bracket with theC-0144Screws.Install theC-5710 Rubber Grommetinto the circular opening of the C-5414 F2 Mounting Bracket and C-6601 Spacer Plate.
  • Remove any existing coin drop.
  • Mount the C-0905 Drop Cover using existing mounting hardware where the coin drop was previously installed.
    • cci-readerinstall-kit
    KitID840
    KitDescCard Only

    ...

    step
    componentPower

    Tap power as described in the document by connecting theC-5211 Power Adapter Harness to the male spade connectors on the machine power panel.
    1. Connect the green wire to the ground terminal.
    2. A corner of the power panel cover may need to be bent slightly to allow the power harness egress.
    Connect the opposite end of theC-5211 Power Adapter Harness to the C-5602 Power Converter.Connect theC-5500-60 Power Extension Harness to the appropriate connector on theC-5602 Power Converter. The remaining cable end connects to the FasCard reader.
    cci-readerinstall-kitstep
    KitID805

    ...

    componentCoin Sense

    cci-readerinstall-kitstep
    KitID704
    KitDescCoin Drop: Factory
    1. Disconnect the Coin Drop from the Machine Control Assembly.
    2. Connect the C-6253 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    componentStart

    Connect theC-5256 Machine Start Harness to the Coin Drop Harness previously connected to the coin drop.
    cci-readerinstall-kitstep
    KitID636
    KitDescPulse

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    1. Feed remaining harness ends through the mounting hole as described in the F2/F3: FasCard Reader Mounting Guide.
    2. Connect the free end of the C-5256 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
    3. Connect the free end of the C-6253 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
    4. Connect the free end of the C-5500-60 Power Harness to port 1.
    5. Secure the FasCard reader to base as described in the FasCard Mounting Guide.

    Machine Configuration

    ...

    componentReader

    Cci readerinstall footer