Versions Compared

Old Version 3

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to for further instructions.
    cci-readerinstall-kitstep
    KitIDcomponent584
    KitDescCoin and Card

    ...

    Mounting

    Cci readerinstall step
    componentPower

    Tap power as described in the document by connecting theC-5338 Power Adapter Harnessto the power distribution panel inside the machine.

    1. 120vac: Connect the Blue wire to L1 and the Brown wire to N. Connect the Green wire to the chassis ground.

    2. 240vac: Connect the Blue wire to L1 and the Brown wire to L2. Connect the Green wire to the chassis ground.

    Connect the opposite end of theC-5338 Power Adapter Harnessto theC-5602 Power Converter.Connect theC-5500Power Extension Harness to the appropriate connector on theC-5602 Power Converter. The remaining cable end connects to the FasCard reader.
    cci-readerinstall-kit
    KitID473

    ...

    step
    componentCoin Sense

    cci-readerinstall-kitstep
    KitID704
    KitDescCoin Drop: Factory
    1. Disconnect the Coin Drop from the Machine Control Assembly.
    2. Connect the C-6253 Coin Sense Harness to the harness connected to the coin drop micro switch.

    ...

    componentStart

    cci-readerinstall-kit
    KitID636
    KitDescPulse
    1. Connect the C-5256 Machine Start Harness to the coin drop harness previously connected to the coin drop micro switch.

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    1. Feed remaining harness ends through the mounting hole as described in the FasCard Mounting Guide.
    2. Connect the free end of the C-5256 Machine Start Harness to port 2 (Pulse Connection Port) as shown in the image above.
    3. Connect the free end of the C-6253 Coin Sense Harness to port 3 (Coin Sense Harness Connection Port) as shown in the image above.
    4. Connect the free end of the C-5500 Power Harness to port 1.
    5. Secure the FasCard reader to base as described in the FasCard Mounting Guide.

    Machine Configuration

    ...

    step
    componentReader

    Cci readerinstall footer