Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Place theC-6700-TEMPDrill Template on the desired mounting location.
  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

  • Refer to for further instructions.
    cci-readerinstall-kitstep
    KitIDcomponent584
    KitDescCoin and Card

    ...

    Mounting

    Cci readerinstall step
    componentPower

    Tap the machine AC power wires using theC-5101Spade Taps.For120vmodels:L1,N, andGroundwiresFor240vmodels:L1,L2, andGroundwiresConnect the three wires from the C-5210 Power Adapter Harnessto theC-5101 Spade Taps.Connect theBluewire to the L1tap.Connect the Brownwire to the N/L2tap.Connect theGreen/Yellowwire to the Groundtap.Connect the 3-pinconnector from the C-5210 Power Adapter Harnessto the matching connector on the C-5602R1 Power Converter.Connect the 4-pinconnector from theC-5602R1 Power Converterto the matching connector on theC-5500Power Extension Harness.Run the C-5500Power Extension Harness to the reader mounting location.
    cci-readerinstall-kit
    KitID595
    KitDescTap Machine Source Power

    ...

    step
    componentCoin Sense

    Cci readerinstall kit
    KitID884
    KitDescFactory - Optical Coin Drop - Coin Sense Portion of Combination Harness
    1. Disconnect the coin sensor from Terminal Board C.

    2. Connect the wires from the coin sensor to the three circuit screw down terminal with the blue, green, and red wires.

      1. Pair the harness wires to the same colored wires from the coin sensor.

    3. Disconnect the wires from the door switch and connect the white wires with female spade terminal connectors to the same locations.

    ...

    Cci readerinstall step
    componentStart

    Cci readerinstall kit
    KitID884
    KitDescFactory - Optical Coin Drop - Start Pulse Portion of Combination Harness
    1. Connect the wires from the Terminal Board C to the three circuit screw down terminal with the blue, green, and black wires.

      1. Pair the machine wires to the the following screw down terminal wires:

        1. Blue wire to blue.

        2. Green wire to green.

        3. Red wire to black.

    2. Take the wires previously connected to the door switch and connect the white wires with male spade terminal connectors to the wires.

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    Cci readerinstall step
    componentReader

    Cci readerinstall footer