Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

  • Refer to for further instructions.
  • Remove existing coin box and coin drop.

  • Attach the C-5414 Standard Mounting Bracket to theC-6922 Mounting Bracket using the (2) C-542010-32 x 1/4" Philips Screws.Install the C-6922 Mounting Bracket into the coin vault opening. Secure in place using the (2) C-1059 10-32 Keps Nuts.
    cci-readerinstall-kit
    KitID584
    KitDescCoin and Card
    Cci readerinstall kit
    KitID932
    KitDescCard Only - 30lb & Smaller Models
    step
    componentMounting

  • Remove existing coin box and coin drop.

  • Attach the C-5414 Standard Mounting Bracket to theC-6920R1Mounting Bracket using the (2) C-542010-32 x 1/4" Philips Screws.
  • Install the C-6920R1 Mounting Bracket into the coin vault opening. Secure in place using the (2) C-1059 10-32 Keps Nuts.

  • cci-readerinstall-kit
    KitID869
    KitDescCard Only - 40lb+ Models

    ...

    step
    componentPower

    Tap power as described in the document by connecting theC-5210Power Adapter Harnessto the power distribution panel inside the machine.
    1. 120vac: Connect the brown and blue wires to connector #2 closest to outside of machine and #4 on terminal side closest to circuit board.

    2. 240vac: Connect the brown and blue wires to connectors 3 and 5 on the terminal side closest to the circuit board.

    3. Secure the green wire beneath the ground screw.

    Connect the opposite end of theC-5210Power Adapter Harnessto theC-5602R1Power Converter.Connect theC-5500Power Extension Harness to the appropriate connector on theC-5602R1Power Converter. The remaining cable end connects to the FasCard reader.
    cci-readerinstall-kit
    KitID595
    KitDescTap Source Machine Power

    ...

    step
    componentCoin Sense

  • Disconnect the Coin Drop from the Machine Control Assembly.
  • Connect theC-6357 Coin Sense Harness to the harness connected to the Coin Drop.
    cci-readerinstall-kit
    KitID716
    KitDescFactory - Optical Coin Drop

    Connect Machine Interface Harness

    Connect theC-5353R1 Machine Start Harness to theCoin 1 connector on the Machine Control Assembly.
    Cci readerinstall kit
    KitID655
    KitDescPulse - Coin
    step
    componentStart

    Connect theC-0126-MLVMachine Start Harness to the RS-232 port on the Machine Control Assembly.Connect theC-5359Machine Start Harness to the Input 1 port on the Machine Control Assembly.
    cci-readerinstall-kit
    KitID814
    KitDescSerial - Compass Control

    Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF2 Reader
    PageWithExcerpt_Reader Ports

    ...

    step
    componentReader

    Cci readerinstall footer