Versions Compared

Old Version 4

changes.mady.by.user Chris Kite

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to FasCard Mounting Guide for further instructions.
    cci-readerinstall-kit
    KitID841
    KitDescCoin and Card

    ...

    step
    componentMounting

    Tap power as described in the Fascard Reader Install - Universal Concepts document by connecting the C-5211 Power Adapter Harness to the male spade connectors on the machine power panel.

    1. Connect the green wire to the ground terminal.

    2. A corner of the power panel cover may need to be bent slightly to allow the power harness egress.

  • Connect the opposite end of the C-5211 Power Adapter Harness to the C-5602 Power Converter.

  • Connect the C-5500-60 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

    • cci-readerinstall-kitstep
    KitID805

    ...

    componentPower

    Cci readerinstall step
    componentCoin Sense

    cci-readerinstall-kitstep
    KitID704
    KitDescCoin Drop: Factory

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6253 Coin Sense Harness to the harness connected to the Coin Drop.

    Connect Machine Interface Harness

    componentStart

    cci-readerinstall-kitstep
    KitID636
    KitDescPulse

    1. Connect the C-5256 Machine Start Harness to the Coin Drop Harness previously connected to the coin drop.

    ...

    componentReader

    Cci readerinstall footer