Versions Compared

Version Old Version 4 New Version Current
Changes made by

Chris Kite

CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to FasCard Mounting Guide for further instructions.
    cci-readerinstall-kit
    KitID841
    KitDescCoin and Card

    Connect Power

    step
    componentMounting

    cci-readerinstall-kitstep
    KitID581
    KitDesc12VDC Accessory Power

    1. Connect the C-6204-4012VDC Power Harness to the H10 connection on the Machine Control Assembly.

      1. Connect the green wire to a chassis ground.

    2. The remaining end (3-pin molex) connects directly to the rear of the F2 FasCard Reader.

    Connect Coin Sense Harness

    componentPower

    cci-readerinstall-kit
    KitID700
    KitDescCoin Drop - Factory Optical

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6250 Coin Sense Harness to the harness connected to the Coin Drop.

    ...

    step
    componentCoin Sense

    Connect the C-5240 Machine Start Harness to the H3 connector on the Machine Control Assembly.
    cci-readerinstall-kit
    KitID582
    KitDescSerial Communication / Pulse
    step
    componentStart

    Cci readerinstall step
    componentReader

    ...