Install Mounting Hardware
...
| KitID | 841 |
|---|
| KitDesc | Coin and Card |
|---|
...
Place the C-6700-TEMP Drill Template on the desired mounting location.
...
Verify included harnesses will reach desired location without encountering interference from internal machine components.
...
| cci-readerinstall-kitstep |
|---|
|
Remove the coin drop and coin box from the machine.Install the C-0926 Drop Coverinto the coin drop opening and secure using the (4) C-1044NM3 Keps Nuts.Install the C-6925AMounting Bracket into the coin vault. Orient so the side the threaded fasteners face outwards towards the front of the machine and are on the bottom portion of the bracket. After inserted into the coin vault, the bracket should catch the coin vault opening when facing flush with the front of the machine.Place the C-6925BMounting Bracket Coverover the coin vault opening so the outer set of holes align with the threaded holes on the C-6925A Mounting Bracket. Then use the (2) C-5751 8-32 x 2-1/2" Screwto secure both brackets together. The C-6925AMounting Bracket enables theC-6925B Mounting Bracket Coverto anchor over the front of the machine.Attach the C-5414 Standard F2 Mounting Bracketto the C-6925B Mounting Bracket Coverusing the (2) C-542010-35 x 1/4" Pan Screws.
Connect Power
...
| KitID | 802 |
|---|
| KitDesc | Tap Machine Source Power |
|---|
...
Connect Coin Sense Harness
| Cci readerinstall kit |
|---|
| KitID | 702 |
|---|
| KitDesc | Coin Drop: Phase 5 Control |
|---|
|
- Disconnect the Coin Drop from the Machine Control Assembly.
- Connect the C-6251 Coin Sense Harness to the harness connected to the Coin Drop.
|
| Cci readerinstall kit |
|---|
| KitID | 722 |
|---|
| KitDesc | Coin Drop: Phase 7 Control |
|---|
|
- Disconnect the Coin Drop from the Machine Control Assembly.
- Connect the C-6368 Coin Sense Harness to the harness connected to the Coin Drop.
|
Connect Machine Interface Harness
| Cci readerinstall kit |
|---|
| KitID | 648 |
|---|
| KitDesc | Pulse - Phase 5 Controls |
|---|
|
- Connect the C-5302 Machine Start Harness to the Coin 1 connection on the Machine Control Assembly.
|
| Cci readerinstall kit |
|---|
| KitID | 653 |
|---|
| KitDesc | Pulse - Phase 7 Controls |
|---|
|
Connect the C-5345 Machine Start Harness to the Coin 1 connection on the Machine Control Assembly. |
|