Page Comparison

Step-by-Step Guide

1. Remove the

1. cash box from the Bill Acceptor located on the inside of the front X-Changer door.
   
   Image Modified
   
   
2. Unplug the power (smaller) and data (larger) cables from the right side of the

1. Bill Acceptor. 
   
   Image ModifiedImage Modified
   
   
2. Remove the four 11/32” nuts holding the bill acceptor on the door and set them aside. Take care not to let it drop to the floor. 
   
   Image AddedImage AddedImage Added
   
   
3. Pull

1. the Bill Acceptor out of the X-Changer door towards

1. the inside and place it on a flat surface.
2. Place the Credit Card Bezel on the front of the Bill Acceptor and

1. attach it with the provided screws.

1.  
   
   Image AddedImage Modified
   
   
2. Place

1. the Bill Acceptor with the attached Credit Card Bezel back into the door of the X-Changer.
   
   Image Added
   
   
2. Put the green ground cable

1. onto the screw stud and replace the four 11/32 kep nuts and hand tighten.
   

1. 
   Image Added
   
   
2. Thread Bezel Serial Cable around the door harness to the back of the computer.
   
   Image Added
   
   
3. Install the

1. Bezel "Y" Cable to the open port on the back of the computer.
   1. Usually, the open SUNIX expansion slot serial port is near the power cable.
      
      Image Added
      
      
2. Plug the flat serial connection from the Credit Card Bezel into the

1. flat serial connection of Bezel "Y" Cable until it clicks.
2. Plug the round barrel connector of the Bezel Power Cable into

1. the rount barrel connector of the Bezel "Y" Cable.
   
   Image Added
   
   
2. Plug the power cable of the Bezel Power Cable into an available outlet on the

1. bottom Tripp-Lite Surge Protector.

Related Articles