/
Installing The MEI Credit Card Combo Bezel

Installing The MEI Credit Card Combo Bezel

 

Required Parts

Required Tools

Phillips head screwdriver

Socket wrench

Socket: 11/32"

Step-by-Step Guide

The installer will need to install the MEI credit card bezel to the front of the X-Changers. You will need an 11/32” deep well socket and a #2 Philips head screwdriver.

  1. Remove the cash box from the Bill Acceptor located on the inside of the front X-Changer door.




  2. Unplug the power (smaller) and data (larger) cables from the right side of the Bill Acceptor




  3. Remove the four 11/32” nuts holding the bill acceptor on the door and set them aside. Take care not to let it drop to the floor. 




  4. Pull the Bill Acceptor out of the X-Changer door towards the inside and place it on a flat surface.

  5. Place the Credit Card Bezel on the front of the Bill Acceptor and attach it with the provided screws. 




  6. Place the Bill Acceptor with the attached Credit Card Bezel back into the door of the X-Changer.




  7. Put the green ground cable onto the screw stud and replace the four 11/32 kep nuts and hand tighten.




  8. Thread Bezel Serial Cable around the door harness to the back of the computer.




  9. Install the Bezel "Y" Cable to the open port on the back of the computer.

    1. Usually, the open SUNIX expansion slot serial port is near the power cable.




  10. Plug the flat serial connection from the Credit Card Bezel into the flat serial connection of Bezel "Y" Cable until it clicks.

  11. Plug the round barrel connector of the Bezel Power Cable into the rount barrel connector of the Bezel "Y" Cable.




  12. Plug the power cable of the Bezel Power Cable into an available outlet on the bottom Tripp-Lite Surge Protector.

Do not plug into the Tripp-Lite Battery Backup at the bottom.

Related Articles

Related content

How-to enable Card Reader Communications (Card Mode) on Machines
How-to enable Card Reader Communications (Card Mode) on Machines
Read with this
C-0999 - X-Changer Security Brackets Installation Guide
C-0999 - X-Changer Security Brackets Installation Guide
More like this
X-Changer Custom Advertising Information
X-Changer Custom Advertising Information
Read with this
_748
More like this
LaundryCard X-Changer Cabinet v2 Parts Manual - Current
LaundryCard X-Changer Cabinet v2 Parts Manual - Current
Read with this
Installing the Updated Acrylic on an Existing V2 X-Changer Cabinet
Installing the Updated Acrylic on an Existing V2 X-Changer Cabinet
More like this