Versions Compared

Old Version 5

changes.mady.by.user Chris Kite

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

  • Place the C-5700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to FasCard Mounting Guide for further instructions.
    cci-readerinstall-kitstep
    KitID616
    KitDescCoin and Card
    componentMounting

  • Place the C-6700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to FasCard Mounting Guide for further instructions.
    cci-readerinstall-kit
    KitID584
    KitDescCoin and Card

    ...

    step
    componentPower

    Tap power as described in the Fascard Reader Install - Universal Concepts document using the C-5101 Spade Taps provided.

  • Connect the C-5210 Power Adapter Harness to the installed spade taps.

  • Connect the C-5210 Power Adapter Harness to the C-5602 Power Converter.

  • Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

  • Connect the opposite end of the C-5210 Power Adapter Harness to the C-5602 Power Converter.

  • Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

    • cci-readerinstall-kit
    KitID595
    KitDescTap Machine Power

    ...

    step
    componentCoin Sense

    Cci readerinstall kit
    KitID886
    KitDescCoin Drop: Coin Micro

    1. Disconnect the existing wires from the Coin Drop and connect the C-6334 Combination Coin/Start Harness to the Coin Drop.

      1. Blue wires go to common (Co) and normally open (NO) on coin switch.

    ...

    Cci readerinstall step
    componentStart

    Cci readerinstall kit
    KitID886
    KitDescPulse - Coin Micro

    1. Disconnect the existing wires from the Coin Drop.

      1. Connect the C-6334 Machine Start Harness to the Coin Drop.

      2. Connect the Violet wires to Blue wires 36 & 35.

      3. White wires wrapped with Violet go to Red wires 207 & 30.

      4. White wires wrapped with Blue go to Brown coin blocking solenoid wires.

        1. Wrap the connectors in electrical tape to keep the bare terminals from exposing.

    ...