Versions Compared

Old Version 5

changes.mady.by.user CCI Integration User

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Warning

Custom Install Scenario

This install guide has been created and intended only for use at FasCard account F0913, where a previous card system is being replaced.

C-5358 coin sense harness is being sent in place of the standard coin sense harness as the previous card system spliced into the coin drop harness.

Cci readerinstall header

Install Mounting Hardware

  • Place the C-5700-TEMP Drill Template on the desired mounting location.

  • Verify included harnesses will reach desired location without encountering interference from internal machine components.

    • Refer to for further instructions.
    cci-readerinstall-kitstep
    KitIDcomponent917
    KitDescCoin and Card

    ...

    Mounting

    Cci readerinstall step
    componentPower

    Tap power as described in the document using theC-5101 Spade Taps provided.Connect theC-5210 Power Adapter Harness to the installed spade taps. Connect the opposite end to theC-5602 Power Converter.Connect theC-5500 Power Extension Harness to the appropriate connector on theC-5602 Power Converter. The remaining cable end connects to the FasCard reader.
    cci-readerinstall-kit
    KitID595

    ...

    step
    componentCoin Sense

    Cci readerinstall kit
    KitID690
    KitDescCoin Drop: Factory

    1. Disconnect the Coin Drop from the previous card reader.

    2. Connect the C-5358 Coin Sense Harness to the harness connected to the Coin Drop.

      1. Connect the White wire from the coin drop to the White wire terminal on C-5358.

      2. Connect the Green wire from the coin drop to the Green wire terminal on C-5358.

      3. Connect the Brown wire from the coin drop to the Brown wire terminal on C-5358

    .

    Connect Machine Interface Harness

    Cci readerinstall kit
    KitID833
    KitDescSerial
    Connect the C-0126-MLV Machine Start Harness to the RS-232 port on the Machine Control Assembly

      1. .

    1. If extra length is needed on the harness, attach C-0126-MLV-EXT15 Extension Harness.
  • Connect the C-5359 Machine Start Harness to the Input port on the Machine Control Assembly.

    • Connect and Mount Reader

    Multiexcerpt include
    SpaceWithExcerptCCIDOC
    MultiExcerptNameF1 Reader
    PageWithExcerpt_Reader Ports

    ...

    Machine Configuration

    ...

    Cci readerinstall footer