0471 Reader Install Guide - Custom Install F0913

Owned by Brett Norrell (Deactivated)
Last updated: Jan 26, 2024 by CCI Integration User
1 min read

Custom Install Scenario

This install guide has been created and intended only for use at FasCard account F0913, where a previous card system is being replaced.

C-5358 coin sense harness is being sent in place of the standard coin sense harness as the previous card system spliced into the coin drop harness.

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Washer Extractor
Manufacturer: Laundrylux
Make: Electrolux
Model Length: Not Set

Associated Models


W5280X
W5300X
W5350X
W5600X
W5600XCC

Recommended Tools and Supplies

  • Drill

  • 1 1/8" Tungsten Carbide Tipped Hole Cutter

  • Cutting Oil

  • 9/64" Drill Bit

  • Center Punch

  • Hammer

  • Fine Point Permanent Marker

  • Pliers

  • Tape Measure

Installation

 I-S0017

Part #: C-5358

Desc 1: Coin Sense Harness (SA)

Desc 2: TD

   Qty: 1

  1. Disconnect the Coin Drop from the previous card reader.

  2. Connect the C-5358 Coin Sense Harness to the harness connected to the Coin Drop.

    1. Connect the White wire from the coin drop to the White wire terminal on C-5358.

    2. Connect the Green wire from the coin drop to the Green wire terminal on C-5358.

    3. Connect the Brown wire from the coin drop to the Brown wire terminal on C-5358.

CCI Software Configuration

Machine ControlPulseSerial
Compass Pro (Gen7)SingleVend (Relay) / ?Laundrylux Compass Pro Washer

Additional Resources