Versions Compared

Old Version 6

changes.mady.by.user Chris Kite

Saved on

compared with

New Version Current

changes.mady.by.user CCI Integration User

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Cci readerinstall header

Install Mounting Hardware

Connect Power

Cci readerinstall step
componentPowerMounting

Tap power as described in the Fascard Reader Install - Universal Concepts document by connecting the C-5101 Power Adapter Harness to the power distribution panel inside the machine.

  1. 120vac: Connect the brown and blue wires to connector #2 closest to outside of machine and #4 on terminal side closest to circuit board.

  2. 240vac: Connect the brown and blue wires to connectors 3 and 5 on the terminal side closest to the circuit board.

  3. Secure the green wire beneath the ground screw.

  • Connect the opposite end of the C-5101 Power Adapter Harness to the C-5602 Power Converter.

  • Connect the C-5500-84 Power Extension Harness to the appropriate connector on the C-5602 Power Converter. The remaining cable end connects to the FasCard reader.

    • cci-readerinstall-kitstep
    KitIDcomponent807
    KitDescChange Me

    Connect Coin Sense Harness

    Cci readerinstall kit
    KitID716
    KitDescCoin Drop: Factory Edge Connector

    1. Disconnect the Coin Drop from the Machine Control Assembly.

    2. Connect the C-6357 Coin Sense Harness to the harness connected to the Coin Drop.

    ...

    Power

    Cci readerinstall step
    componentPower

    Cci readerinstall step
    componentCoin Sense

    Connect the C-5353R1 Machine Start Harness to the Coin 1 connector on the Machine Control Assembly.
    cci-readerinstall-kit
    KitID655
    KitDescPulse - Edge Connector
    step
    componentStart

    Attach
    Cci readerinstall kit
    KitID830605
    KitDescPulse - Terminal Connector with Block

    1. Connect the bare wire ends of the C-5313 Terminal Block to the Machine Control Assembly.Connect the C-5356 0111-RES Machine Start Harness to the Positions 2 and 3 on the terminal block.

    2. Terminal block

      positions

      connections are numbered 0-6

      . Position 0 is closest to the board edge

      from the edge nearest the top of the board (position 0) to the bottom of the terminal block (position 6)

      • For machines shipped before 1/1/2006, connect harness to positions 1 and 3.

      • For machines shipped after 1/1/2006, connect harness to positions 3 and 5.

      • For machines shipped near 6/1/2007, connect harness to positions 2 and 3.

      • All other machines, connect harness to positions 3 and 4.

    Cci readerinstall step
    componentReader

    ...