Install Mounting Hardware
...
| KitID | 616 |
|---|
| KitDesc | Coin and Card |
|---|
...
Place the C-5700-TEMP Drill Template on the desired mounting location.
...
Verify included harnesses will reach desired location without encountering interference from internal machine components.
...
| cci-readerinstall-kit |
|---|
| KitID | 905 |
|---|
| KitDesc | Card Only - Card Model |
|---|
|
Place the C-5700-TEMP Drill Template on the desired mounting location.
Verify included harnesses will reach desired location without encountering interference from internal machine components.
Refer to FasCard Mounting Guide for further instructions.
...
| cci-readerinstall-kit |
|---|
| KitID | 595 |
|---|
| KitDesc | Tap Machine Source Power |
|---|
|
Tap power as described in the Fascard Reader Install - Universal Concepts document by connecting the C-5210 Power Adapter Harness to the power distribution panel inside the machine.120vac: Connect the blue wire to L1 and the brown wire to N.
240vac: Connect the blue wire to L1 and the brown wire to L2.
Connect the green wire to ground.
Connect the opposite end of the C-5210 Power Adapter Harness to the C-5602R1 Power Converter.
Connect the C-5500 Power Extension Harness to the appropriate connector on the C-5602R1 Power Converter. The remaining cable end connects to the FasCard reader.
...
| cci-readerinstall-kit |
|---|
| KitID | 674 |
|---|
| KitDesc | Factory - Optical Coin Sensor |
|---|
|
Disconnect the Coin Drop from the Machine Control Assembly.
Connect the C-5250 Coin Sense Harness to the harness connected to the Coin Drop.| step |
|---|
|
|
| cci-readerinstall-kitstep |
|---|
| KitID | 677 |
|---|
| KitDesc | Factory - Coin Slide Switch |
|---|
|
Disconnect the factor coin drop harness from the microswitch on the coin drop. Connect the C-5253 Coin Sense Harness to the microswitch on the the coin drop.
|
Connect Machine Interface Harness
| cci-readerinstall-kitstep |
|---|
| KitID | 645 |
|---|
| KitDesc | Pulse - Optical Coin Sensor |
|---|
|
Connect the C-5300-NC Machine Start Harness to the Coin 1 connection on the Machine Control Assembly. |
|
| cci-readerinstall-kitstep |
|---|
| Cci readerinstall kit |
|---|
| KitID | 603 |
|---|
| KitDesc | Serial - MDC Control |
|---|
|
Connect the C-0110-TOP Machine Start Harness to the H3 connector on the Machine Control Assembly.
Connect the C-0110-CP Jumper Plug to the H6 connection on the Machine Control Assembly.| KitIDcomponent | 636 |
|---|
| KitDesc | Pulse - Coin Slide Microswitch |
|---|
|
Connect the C-5256 Machine Start Harness to the factory coin harness previously connected to the micro switch on the coin drop.
|
|
|