...
| width | 30 |
|---|
| Panel |
|---|
...
|
...
|
...
|
...
|
...
|
...
| width | 70 |
|---|
|
...
This page is intended to provide the reader with generalized details and functions of the Satellite Access Point (SAP) utilized in all FasCard & FLEX systems. |
...
| Bw part list | ||||
|---|---|---|---|---|
|
General information
The Satellite Access Point (SAP) acts as a bridge between the FasCard readers, Internet, and FasCard Administration Site. To connect these components together, the SAP contains two ethernet ports intended for wired Internet communication and an internal wireless antenna that communicates with
...
the FasCard readers.
...
The SAP is more than
...
an average Wireless Access Point (WAP) in that it provides valuable location status information to
...
the FasCard Admin Site dynamically. Meaning, it doesn't have to be manually updated.
Each FasCard location must have a minimum of one (1) SAP to function properly. Multiple SAPs can be used to extend the wireless coverage area or provide redundancy.
...
As many as 110 card readers can be managed by a single SAP, although there are various factors where more SAPs may be required. The current wireless range of
...
an individual SAP is approximately 90 feet, providing coverage
...
in a 180-foot diameter
...
around the SAP.
...
While the wireless signal will operate through walls and objects, signal strength may be degraded and interference from sources generating strong electromagnetic fields is
...
also likely to create issues.
...
| Tip | ||
|---|---|---|
| ||
CCI recommends installing the SAP on the ceiling or high up on a pillar, located in the middle of most (or all) readers and Kiosks to provide even coverage. |
The SAP can be powered either by a Power over Ethernet (PoE) adapter or a standard 12VDC adapter. The former eliminates the need to install a wall receptable, or other power source, at the SAPs install site.
...
Power for
...
the SAP is delivered through
...
a Cat5 Ethernet cable that connects the device to the local internet connection by way of
...
the PoE adapter utilized during installation
...
. The 12VDC adapter is shorter in length, and will require a power source of sorts to be as close as possible to the SAPs install site.
| Note | ||
|---|---|---|
| ||
The FasCard SAP (Mikrotik 951G-2HnD) device can accept power through its power jack or through the first Ethernet port:
|
Additional hardware included with the SAP
| Bw part list | ||||
|---|---|---|---|---|
|
...
|
...
|
Additional
...
information
...
...
...
...