| Table of Contents |
|---|
📄 Overview
The existing C-1025 Card Dispenser housed in modern X-Changers holds a capacity of approximately 120 cards. This guide will go over the process of installing the C-1029 Card Dispenser Extension Bracket for increasing the capacity.
🪛 Requirements
...
| Bw part list | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
A C-1029-SA Card Dispenser Extension Kit, which includes:
A C-1029 Card Dispenser Extension Bracket.
Five (
5) C-1074 2/56x1/4 0.05” 18-8 stainless steel flat socket cap hex screws.
Five (
5) C-1074N 2/56 steel hex cap nuts.
A C-5435 0.050” hex key.
Alternatively, a 0.
050” (1.3mm
) hex
bit/driver may also be utilized.
A Philips Screwdriver (preferably PH1 tip).
Access to the front of the X-Changer.
Needle-nose pliers.
\uD83D\uDCD8 Instructions
Open the X-Changer Cabinet Door from the front.
Disconnect the card dispenser harness and remove any cards and weight from the existing card dispenser.
...
Once aligned, insert one C-1074 Hex Screw into one of the four (4) the applicable screw holes and begin to fasten the C-1074N Hex Cap Nut onto the screw until you can no longer fasten the screw and nut by hand.
 |  |
Using the C-5435 0.050” Hex key, or a 0.050” (1.3mm) hex key or bit/driver and needle nose pliers, tighten the four (4) hex screws and nuts in place. You can feed a screwdriver or long hex key through each hole above the mounting points to reach the adjacent hex screw for tightening.
...
Reload customer loyalty cards to capacity and reattach the card dispenser harness.
The increase in allowed card volume should now exceed the height of the dispenser hopper.
 |  |
Reapply With a Phillips Screwdriver, remove the chain from the card dispenser weight and reapply the card dispenser weight.
\uD83D\uDCCB Related
| Filter by label (Content by label) | ||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|