đź“„ Overview
The existing C-1025 Card Dispenser housed in modern X-Changers holds a capacity of approximately 120 cards. This guide will go over the process of installing the C-1029 Card Dispenser Extension Bracket for increasing the capacity.
🪛 Requirements
Access to the front of the X-Changer.
A C-1029 Card Dispenser Extension Bracket.
Four (4) C-1074 2/56x1/4 0.05” flat socket cap hex screws.
Four (4) C-1074N 2/56 hex cap nuts.
A 0.05” or 1.3mm long hex key and/or precision screwdriver / bit and driver.
Needle-nose pliers.
\uD83D\uDCD8Â Instructions
Open the X-Changer Cabinet Door from the front.
Disconnect the card dispenser harness and remove any cards and weight from the existing card dispenser.
 |  |
At this stage, if you prefer to install the C-1029 Card Dispenser Extension Bracket onto the card dispenser away from the X-Changer, you can unmount the card dispenser and relocate to another secure flat surface such as a table. Otherwise, you can mount the extension bracket directly from within the X-Changer door panel.
Position the extension bracket to be held in place length-wise with the opening facing the back of the dispenser with the screw holes lined up.
 |  |
Once aligned, insert one C-1074 Hex Screw into one of the four (4) the applicable screw holes and begin to fasten the C-1074N Hex Cap Nut onto the screw until you can no longer fasten the screw and nut by hand.
 |  |
Using a 0.050” (1.3mm) hex key or bit/driver and needle nose pliers, tighten the four (4) hex screws and nuts in place. You can feed a screwdriver or long hex key through each hole above the mounting points to reach the adjacent hex screw for tightening.
 |  |
 |  |
Reload customer loyalty cards to capacity and reattach the card dispenser harness.
The increase in allowed card volume should now exceed the height of the dispenser hopper.
 |  |
Reapply the card dispenser weight.
