| Panel | ||
|---|---|---|
| ||
This document provides a general overview of setting LG C-Washers into "Card mode". |
| Warning |
|---|
DO NOT USE CARD MODE FOR PULSE CONFIGURATIONS The machine requires a special command from a |
...
serial harness to be set back into coin mode. |
...
Installation prerequisite
Check the Machine Start Harness to verify that you are using the Serial Connector, pictured below.
|
|
| Serial connector | Pulse connector |
| Info |
|---|
FasCard LG Giant-C firmware 1.00.22 and higher allow a manager card with System Maintenance privileges to gain access to the machines service mode through the Maintenance menu on the card reader. |
...
Vend type programming
Before the vend type can be set on the reader, the machine must be in Programming Mode.
Configure Vend Type:
Configuring vend type
Related documents
| Filter by label (Content by label) | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|