...
Class | toc-header |
---|
...
width | 30 |
---|
Panel |
---|
...
|
...
|
...
|
...
|
...
|
...
|
...
| ||
These install instructions are for converting coin ready A-Micro controlled machines (HCxxAC2 or HCxxACV) to card ready, which allows for multi-level vend pricing, including 'Extra Wash' and 'Extra Rinse' options. This kit requires that the machine be upgraded to include serial communication hardware that consists of a special daughter board and a specific micro ship available only from Alliance Laundry Systems. |
Panel | ||||||||
---|---|---|---|---|---|---|---|---|
| ||||||||
|
Required Hardware
The following Alliance parts must be obtained from Alliance Laundry Systems if not already installed.
Part Number | Description |
---|---|
F200017400P | Interface CCA (Daughter Board) |
F8228701 (AC2 Models) F8228702 (ACV Models) | Serial communication EPROM Chip |
Installation
Change pricing to 1pr and set vend to 1.50 and extra wash and rinse to .25 by the following steps.
- With original coin chip installed flip program switch to the left to program mode "tSFL" appears on screen.
- Press "rugs/blanket Cold" button which has * printed on it.
- Display will show model and size example "HC20_" for 20# machine.
- Press Start Display reads "nOd1" for one second then displays extra wash add cost.
- Use "extra Wash" for increase "extra rinse" for decrease to .25 then press "start"
- "nOd2" is displayed for one second then displays extra rinse add cost.
- Use "extra Wash" for increase "extra rinse" for decrease to .25 then press "start"
- Use Start key to advance past programming steps:
"Far"
"nOHt"
"nEFL" - Next step needs to be set to "1Pr" using the Extra Wash to toggle from "6Pr"
- Next change Value "AntStrt" to $1.50 using Extra Wash key for increase or Extra Rinse key for decrease hit start key until "tSFL" appears then flip program switch back to run mode.
- Check that all 6 cycles are 1.50 and extra wash is .25 and Extra rinse is .25
- Cut power off from machine.
- Install Card Chip with half circle marking in correct orientation with chip socket on main board
For the “AC2” (2-Speed) Control, you would need to order P/N F8228701, to make it a “AY2”.
For the “ACV” (V- Speed) Control, you would need to order P/N F8228702, to make it a “AYV”. - Install Daughter board F200017400P onto left side of control lining up the black female socket with the pins on control and tighten the 2 nuts to secure.
- Install card reader and harnesses per instructions
- Power on machine.
- After dashes clear and correct price from Fascard reader is displayed on Washer display flip program switch to program side. “tSFL” appears on display.
- Push "rugs/blanket Cold" (*) key
- Push start key several times until "tSFL" appears again.
- Flip program switch back to run mode and test start.