Skip to end of banner
Go to start of banner

3545 Reader Install Guide

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 7 Next »

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Tumble Dryer (Single)
Manufacturer: ADC
Make: ADC
Model Length: Not Set

Customer will need to confirm if the control is Phase 5 or Phase 7 to confirm which start and coin sense harnesses are required.

Associated Models


AD758
AD758V
ADG758
ADG758V

Recommended Tools and Supplies

  • Drill

  • 1 1/8" Tungsten Carbide Tipped Hole Cutter

  • Cutting Oil

  • 9/64" Drill Bit

  • Center Punch

  • Hammer

  • Fine Point Permanent Marker

  • Pliers

  • Tape Measure

Installation

Install Mounting Hardware

 I-M0035

Part #: C-0015

Desc 1: Label

Desc 2: Reader Cover Label

   Qty: 1

Part #: C-0141

Desc 1: Screw

Desc 2: 8-32 x 1-1/2" - Cap

   Qty: 2

Part #: C-0930

Desc 1: Mounting Bracket

Desc 2: Unimac/ADC

   Qty: 1

  1. Remove any existing coin drop.

  2. Open the control door panel on the machine.

  3. Place the C-0930 Mounting Bracket on the inside of the control door panel and over the coin drop opening. Align the C-0930 Mounting Bracket so the pairs of threaded holes are on the sides of the opening.

  4. From the outside of the control door panel, insert the card reader through the coin drop opening and the inner cutout of the C-0930 Mounting Bracket.

  5. Align the screw holes of the card reader to the lower set of threaded holes on the C-0930 Mounting Bracket and then attach using the (2) C-0141 8-32 x 1-1/2" cap screws, ensuring the card reader is placed to cover the coin drop opening.

Connect Power

Connect Coin Sense Harness

Connect Machine Interface Harness

Connect and Mount Reader

CCI Software Configuration

Machine ControlPulseSerial
Phase 5SingleVend (Relay) / 60ms*NOT SUPPORTED*
Phase 7SingleVend (Relay) / 60ms*NOT SUPPORTED*

Additional Resources

  • No labels