3278 Reader Install Guide

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Washer
Manufacturer: Dexter
Make: Dexter
Model Length: Not Set

For Fascard Kit# K-5723
There is no terminal block on that machine and the only way to get power is to tap the harness C-5338. The Brown and Blue to two hots and the green to ground. They will need wire taps to do this otherwise they would need a different harness.

Associated Models

WCL25AA
WCL25AB
WCL55AA
WCN18AASS
WCN18ABNS
WCN18ABSS
WCN25AA
WCN25AASS
WCN25AB
WCN25ABNS
WCN25ABSS
WCN40AASS
WCN40ABNS
WCN40ABSS
WCN50ABSS
WCN55AASS
WCN55ABSS

Recommended Tools and Supplies

Drill
1 1/8" Tungsten Carbide Tipped Hole Cutter
Cutting Oil
9/64" Drill Bit
Center Punch
Hammer
Fine Point Permanent Marker
Pliers
Tape Measure

Installation

Install Mounting Hardware

Connect Power

Connect Coin Sense Harness

I-S0031

Part #: C-6253

Desc 1: Coin Sense Harness

Desc 2: 28"

Qty: 1

Disconnect the Coin Drop from the Machine Control Assembly.
Connect the C-6253 Coin Sense Harness to the harness connected to the Coin Drop.

Connect Machine Interface Harness

Connect and Mount Reader

CCI Software Configuration

Machine Control	Pulse	Serial
A-Series (1.0)	SingleVend (Relay) / 150ms	NOT SUPPORTED