Skip to end of banner
Go to start of banner

3670 Reader Install Guide

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 16 Current »

Warning!

This document assumes the installer has working knowledge of hand tools and of the target machine in question. Physical modification of machine may be required, including modification of machine panels and internal modification to accommodate cables or harnesses.

It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks. Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Overview

Equipment Details

Type: Front Load Washer
Manufacturer: Maytag
Make: Whirlpool
Model Length: 10

Associated Models


CHW9050AW0
CHW9060AW0

Recommended Tools and Supplies

  • Drill

  • 1 1/8" Tungsten Carbide Tipped Hole Cutter

  • Cutting Oil

  • 9/64" Drill Bit

  • Center Punch

  • Hammer

  • Fine Point Permanent Marker

  • Pliers

  • Tape Measure

Installation

Removing the Front Panel

  1. Remove the (4) security torx retaining screws on the front of the machine.

    maytagFLWstep1.JPG
  2. Remove the soap tray by pulling it out and pressing on the retaining tab in the rear of the tray.

    maytagFLWstep5.JPGmaytagFLWstep4.JPG
  3. Locate and remove the (2) security torx screws inside the soap tray opening.

    maytagFLWstep3.JPG
  4. Remove the final (2) torx screws to open the top cover.

    maytagFLWstep6.JPG

Install Mounting Hardware

Connect Power

Machine Configuration

  1. Enter Service Mode and navigate to J option.

  2. Set option to J.d.

  3. Exit Service Mode.

  • No labels