Skip to end of banner
Go to start of banner

Barcode Scanner Preventive Maintenance

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 5 Current »


Items Needed

ItemImage
Lint-Free Cloth

Windex

Phillips Head Screw Driver (As needed for adjustments)

Cleaning

Frequency of Maintenance:  Every Two Months

The lens of the scanner should be cleaned with non-abrasive cleaner such as rubbing alcohol.

Never spray anything directly onto the bar code scanner directly. It is suggested to lightly moisten the paper towel and wipe clean the eye of the bar code scanner.

Adjustments

  1. Slide the C-1024C bracket completely to the right, then rotate it clockwise so the silver connector at the top is pointing to about 2 minutes after midnight on the face of a clock (Use image below for reference).
  2. Screw in the scanner set screw located just to the left of the scanner and tighten slightly. It is now time to test the adjustment.
Rotate ScannerAlign Scanner HarnessTighten Set Screw

  1. Slowly adjust the scanner in millimeter increments by twisting the assembly clockwise while dispensing cards incrementally to test the adjustment.
  2. Adjusting the scanner requires some trial and error as the multi-laser design of the scanner means there is no single perfect alignment.
  3. CCI recommends successfully dispensing 25-50 cards in a row before tightening the set-screw and then testing another 25-50 cards with the door closed and locked.

    Laser AimingLaser Cross-Hair Position

  • No labels