If the customer has chosen to accept credit cards on the system and CCI is still supporting the MEI Credit Card Bezel, follow the below instructions for installation
MEI Credit Card Bezel (Yellow)
The installer will need to install the MEI credit card bezel to the front of the X-Changers. You will need an 11/32” deep well socket and a #2 Philips head screwdriver.
- Remove the cassette from the bill acceptor.
- Unplug the power (smaller) and data (larger) cables from the side of the bill acceptor.
- Remove the four 11/32” nuts holding the bill acceptor on the door and set aside. Take care not to let it drop to the floor.
- Pull bill acceptor / credit card bezel out of the X-Changer door towards inside.
- Remove 4 Phillips head screws off the front of the Bill Acceptor and remove the black plastic bezel and the steel plate underneath.
- Place the Credit Card Bezel on the Bill Acceptor and replace the screws. Take care not to kink the cable on the bezel.
- Place bill acceptor back into the door of the X-Changer.
- Put green ground cable on to screw stud and replace the four 11/32 kep nuts and hand tighten.
- Thread serial cable around the door harness to the back of the computer.
- Install the serial adapter to the open port on the back of the computer.
- Plug the flat serial connection into the adapter until it clicks.
- Plug the round barrel connector into the adapter then plug into an available outlet on the surge protectors. Do not plug into the battery backup at the bottom.