Overview
Card reader programming varies depending upon card reader model. Select the appropriate tab below, based upon card reader model number.
Programming Instructions
Items Needed
| Card Reader (C-0100) |
|---|
 |
Programming Steps
- Identify desired unit address for card reader.
- Set dip switches in combination to equal the unit address value. See below for an explanation of dip switching. Dip Switch Cheat Sheet
Dip Switch Values
Each switch has a value associated with it, as shown in the table below. Turning switches ON causes their values to be added together.
Switch 1 | Switch 2 | Switch 3 | Switch 4 | Switch 5 | Switch 6 | Switch 7 | Switch 8 |
|---|---|---|---|---|---|---|---|
128 | 64 | 32 | 16 | 8 | 4 | 2 | 1 |
For example turning switch numbers 8 (1) and 7 (2) on represents the value of 3, or turning on switch numbers 4 (16), 6 (4), and 8 (1) equals 21. Using this binary chart you can achieve any number between 1 and 255.
Needed
| Program Card (C-2PROGRAM) | Card Reader (C-0101, C-0102, C-0103) |
|---|---|
 |  |
Programming Steps
- Identify desired unit address for card reader.
- Power cycle card reader.
- Insert Program card, reader will display:
Set Address: 0**
Dip Card to Set - To increase current digit: Insert tip of card and remove quickly.
- To move to next digit: Insert card fully and wait (approx 2 seconds).
- After accepting last digit of unit address, reader will display:
Storing Value
Remove Card Now
Video Tutorial
|