Skip to end of banner
Go to start of banner

_LC Reader Installation

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 32 Next »

Overview

This document is intended to guide the user through installation utilizing the kit numbered according to the document title. A list of associated equipment models including control information and additional installation notes can be found below. This guide further assumes that all relevant Cat5 cables have been run to the point of connection for the LaundryCard reader being installed. Further information regarding cabling can be found in the Cat5 Cable Running Guide.

Install Header

Disclaimer

This document assumes the installer has working knowledge of hand tools and of the target machine in question. It is recommended that the instructions contained herein be performed by individuals who are qualified to perform these tasks.

Card Concepts Inc. takes no responsibility for the accuracy of this document or for any damage that may occur to target machine.

Required Hardware

Card Reader

Part IDDescription
C-0103-B

Multi-Vend / Bootloader

Requires C-2PROGRAMCARD

LC Tools

  • Various Cat5 cables
    • If terminating cables, include Cat5 RJ-45 stripper/crimper
  • Cat5/RJ-45 line tester
  • 3/32 allen key (card reader screws)
  • Philips Screwdriver w/ multiple bits
  • Flathead Screwdriver
  • Standard socket set
  • Utility Knife
  • Cable/Zip Ties

Ports

LaundryCard Reader Ports

Warnings

 

 

 

  • No labels